Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 8 Next »

Two-factor authentication (2FA) increases the security of our CMS by requiring a single-use code in addition to your password.

How to set up 2FA

Next time you log in to your CMS account, you’ll be required to set up 2-factor authentication.

  1. Navigate to your CMS login screen (e.g. content.vic.gov.au).

  2. Enter your username and password and click ‘Log in’.

  3. You’ll see a warning message ‘You need to enable two-factor authentication’.

    image-20240910-064051.png

  4. Scroll down and click on the ‘Enable Email OTP’ link. You’ll be asked to enter your password again.

    image-20240910-064242.png

  5. Tick the checkbox and click ‘Save’.

    image-20240910-032804.png

  6. The screen will change to show ‘TFA enabled’. You can then start working in the CMS.

    image-20240910-061820.png

  7. The next time you log in, you’ll see the following screen. You’ll see that the Verify button is greyed out. Click the Send button. (The screen will refresh and the Verify button will now be blue and available.)

    image-20240910-055319.png

  8. Go to your mail app/site and find the email with the code. Copy the code into the field and click on Verify.

  9. If you didn’t enter the code from your email before it expired, you can click the Resend button.

  • Each code sent to your email is set to expire after 10 minutes.

  • Each code expires after it is used.

Your email address must be current in your CMS account

Before you set up your 2FA, it’s important that your user account has your current email address.

You can check and update this by clicking on your username at the top of the screen and then Edit profile.

  1. image-20240910-043403.png

Troubleshooting and getting help

Failed validation limit reached

You get 6 attempts within a 5-minute period to get your 6-digit 2FA verification code correctly.

If you get all 6 attempts wrong, you will see:

Error message:

Failed validation limit reached. 6 wrong codes in 5 min. Try again later.

If you reach the validation limit:

  1. Wait 5 minutes.

  2. Go to your CMS log in screen and try again.

    1. Refreshing or trying to log in again on the page you received the ‘failed validation limit’ page will result in a ‘page not found’ error.

If you are still receiving the ‘failed validation limit reached’ message after waiting 5 minutes, fill out an SDP support request. Be descriptive in your request so we can assist you as quickly as possible. 

 

  • No labels